The purpose of this study was to evaluate the in vivo effectiveness of laser fluorescence compared to visual inspection and radiography for the detection of occlusal caries in primary teeth. Fifty sites from 30 molars in 29 patients were selected and evaluated under standardized conditions by 2 previously trained examiners according to the 3 diagnostic methods. Histological examination served as gold standard after exfoliation or extraction. Values obtained for sensitivity, specificity and accuracy were 0.60, 0.90 and 0.73 for laser fluorescence, 0.82, 0.85 and 0.84 for visual inspection and 0.62, 0.73 and 0.67 for radiography, respectively. Considering only dentinal caries, values were 0.73, 0.95 and 0.90 for laser fluorescence, 0.61, 1.00 and 0.90 for visual inspection and 0.96, 0.81 and 0.85 for radiography, respectively. We conclude that for the detection of occlusal caries in primary molars laser fluorescence presents a similar accuracy when compared to visual inspection and radiography, although visual inspection showed better values for sensitivities for both enamel and dentin lesions.
The present data suggested that there were differences in the distribution of genotypes of S. mutans according to the oral site and that S. mutans populations differ in their acid susceptibility and ability to form biofilms, factors allowing their colonization of sucrose-rich environments.
The purpose of this study was to assess bond strength of three self-etching and two total-etch adhesive systems bonded to primary tooth enamel and dentin. Materials and methods: Forty extracted primary human molars were selected and abraded in order to create flat buccal enamel and occlusal dentin surfaces. Teeth were assigned to one of the adhesive systems: Adper Scotch Bond Multi Purpose, Adper Single Bond 2,Adper Prompt L-Pop, Clearfil SE Bond and AdheSE. Imediately to adhesive aplication, a composite resin(Filtek Z250) block was built up. After 3 months of water storage, each sample was sequentially sectioned in order to obtain sticks with a square cross-sectional area of about 0.72 mm2. The specimens were fixed lengthways to a microtensile device and tested using a universal testing machine with a 50-N load cell at a crosshead speed of 0.5 mm/min. Microtensile bond strength values were recorded in MPa and compared by Analysis of Variance and the post hoc Tukey test (a=0.05). Results: In enamel, Clearfil SE Bond presented the highest values, followed by Adper Single Bond 2, AdheSE and Adper Scotch Bond Multi Purpose, without significant difference. The highest values in dentin were obtained with Adper Scotch Bond Multi Purpose and all other adhesives did not present significant different values from that, except Adper Prompt L-Pop that achieved the lowest bond strength in both substrates. Adper Scotch Bond Multi Purpose and Adper Single Bond 2 presented significantly lower values in enamel than in dentin although all other adhesives presented similar results in both substrates. Conclusions: contemporary adhesive systems present similar behaviors when bonded to primary teeth, with the exception of the one-step self-etching system; and selfetching systems can achieve bond strength values as good in enamel as in dentin of primary teeth.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.