The tandem solar cell architecture is an effective way to harvest a broader part of the solar spectrum and make better use of the photonic energy than the single junction cell. Here, we present the design, synthesis, and characterization of a series of new low bandgap polymers specifically for tandem polymer solar cells. These polymers have a backbone based on the benzodithiophene (BDT) and diketopyrrolopyrrole (DPP) units. Alkylthienyl and alkylphenyl moieties were incorporated onto the BDT unit to form BDTT and BDTP units, respectively; a furan moiety was incorporated onto the DPP unit in place of thiophene to form the FDPP unit. Low bandgap polymers (bandgap = 1.4-1.5 eV) were prepared using BDTT, BDTP, FDPP, and DPP units via Stille-coupling polymerization. These structural modifications lead to polymers with different optical, electrochemical, and electronic properties. Single junction solar cells were fabricated, and the polymer:PC(71)BM active layer morphology was optimized by adding 1,8-diiodooctane (DIO) as an additive. In the single-layer photovoltaic device, they showed power conversion efficiencies (PCEs) of 3-6%. When the polymers were applied in tandem solar cells, PCEs over 8% were reached, demonstrating their great potential for high efficiency tandem polymer solar cells.

Silver nanowire (AgNW) networks are promising candidates to replace indium-tin-oxide (ITO) as transparent conductors. However, complicated treatments are often required to fuse crossed AgNWs to achieve low resistance and good substrate adhesion. In this work, we demonstrate a simple and effective solution method to achieve highly conductive AgNW composite films with excellent optical transparency and mechanical properties. These properties are achieved via sequentially applying TiO(2) sol-gel and PEDOT:PSS solution to treat the AgNW film. TiO(2) solution volume shrinkage and the capillary force induced by solvent evaporation result in tighter contact between crossed AgNWs and improved film conductivity. The PEDOT:PSS coating acts as a protecting layer to achieve strong adhesion. Organic photovoltaic devices based on the AgNW-TiO(2)-PEDOT:PSS transparent conductor have shown comparable performance to those based on commercial ITO substrates.

Anionic dopants have been used to reduce the overall sheet resistance of carbon nanotube and graphene films for transparent conductor applications. These enhanced electronic properties are attributed to an increased number of p-type charge carriers. While there have been many reports of its use, there is little reported insight into the chemical interactions of a commonly used dopant, thionyl chloride (SOCl 2 ), with pristine graphene and its chemically converted derivatives. Here, we explore the effects of thionyl chloride on the physical and chemical properties of graphene and hybrid graphene-carbon nanotube films, focusing on how the changes in conductivity correlate to the morphology of chemically converted graphene and carbon nanotube composites.