This paper reviews the requirements and current status of cathodes for accelerator applications, and proposes a research and development plan for advancing cathode technology. Accelerator cathodes need to have long operational lifetimes and produce electron beams with a very low emittance. The two principal emission processes to be considered are thermionic and photoemission with the photocathodes being further subdivided into metal and semiconductors. Field emission cathodes are not included in this analysis. The thermal emittance is derived and the formulas used to compare the various cathode materials. To date, there is no cathode which provides all the requirements needed for the proposed future light sources. Therefore a three part research plan is described to develop cathodes for these future light source applications.

Electron injectors delivering relativistic electron beams with very high brightness are essential for a number of current and proposed electron accelerator applications. These high brightness beams are generally produced from photoemission cathodes. We formulate a limit on the electron beam brightness from such cathodes set by the transverse thermal energy of the electrons leaving the photocathode and the accelerating field at the cathode. Two specific examples--direct measurement of the transverse phase space of a space charge dominated beam from a high-voltage photoemission electron gun and a numerical optimization of the same at a higher gun voltage--illustrate the importance of this limit.

High-power, high-brightness electron beams are of interest for many applications, especially as drivers for free electron lasers and energy recovery linac light sources. For these particular applications, photoemission injectors are used in most cases, and the initial beam brightness from the injector sets a limit on the quality of the light generated at the end of the accelerator. At Cornell University, we have built such a high-power injector using a DC photoemission gun followed by a superconducting accelerating module. Recent results will be presented demonstrating record setting performance up to 65 mA average current with beam energies of 4-5 MeV. V

The thermal emittance and temporal response of a photocathode set an upper limit on the maximum achievable electron beam brightness from a photoemission electron source, or photoinjector. We present measurements of these parameters over a broad range of laser wavelength for two different negative electron affinity ͑NEA͒ photocathodes. The thermal emittance of NEA GaAs and GaAsP has been measured by two techniques-a measurement of the beam size downstream from a solenoid, whose strength was varied, and a double slit transmission measurement-for different laser spot sizes and shapes. The effect of space charge on the beam spot size allows a good estimation of the photoemission response time from these cathodes. Both cathodes show a subpicosecond response for laser wavelengths shorter than 520 nm.

Substantially more than half of the electromagnetic nuclear physics experiments conducted at the Continuous Electron Beam Accelerator Facility of the Thomas Jefferson National Accelerator Facility (Jefferson Laboratory) require highly polarized electron beams, often at high average current. Spinpolarized electrons are produced by photoemission from various GaAs-based semiconductor photocathodes, using circularly polarized laser light with photon energy slightly larger than the semiconductor band gap. The photocathodes are prepared by activation of the clean semiconductor surface to negative electron affinity using cesium and oxidation. Historically, in many laboratories worldwide, these photocathodes have had short operational lifetimes at high average current, and have often deteriorated fairly quickly in ultrahigh vacuum even without electron beam delivery. At Jefferson Lab, we have developed a polarized electron source in which the photocathodes degrade exceptionally slowly without electron emission, and in which ion back bombardment is the predominant mechanism limiting the operational lifetime of the cathodes during electron emission. We have reproducibly obtained cathode 1/e dark lifetimes over two years, and 1/e charge density and charge lifetimes during electron beam delivery of over 2 10 5 C=cm 2 and 200 C, respectively. This source is able to support uninterrupted high average current polarized beam delivery to three experimental halls simultaneously for many months at a time. Many of the techniques we report here are directly applicable to the development of GaAs photoemission electron guns to deliver high average current, high brightness unpolarized beams.