This report describes affinity measurements for two, water-soluble, methyl-alkylated diamides incorporating the malonamide functionality, N,N,N',N' tetramethylmalonamide (TMMA) and a bicyclic diamide (1a), toward actinide metal cations (An) in acidic nitrate solutions. Ligand complexation to actinides possessing oxidation states ranging from +3 to +6 was monitored through optical absorbance spectroscopy, and formation constants were obtained from the refinement of the spectrophotometric titration data sets. Species analysis gives evidence for the formation of 1, 4, 1, and 2 spectrophotometrically observable complexes by TMMA to An(III, IV, V, and VI), respectively, while for 1a, the respective numbers are 3, 4, 2, and 2. Consistent with the preorganization of 1a toward actinide binding, a significant difference is found in the magnitudes of their respective formation constants at each complexation step. It has been found that the binding affinity for TMMA follows the well-established order An(V) < An(III) < An(VI) < An(IV). However, with 1a, Np(V) forms stronger complexes than Am(III). The complexation of 1a with Np(V) and Pu(VI) at an acidity of 1.0 M is followed by reduction to Np(IV) and Pu(IV), whereas TMMA does not perturb the initial oxidation state for these dioxocations. These measurements of diamide binding affinity mark the first time single-component optical absorbance spectra have been reported for a span of actinide-diamide complexes covering all common oxidation states in aqueous solution.

No abstract

No abstract

This report describes an investigation into the coordination chemistry of trivalent lanthanides in solution and the solid state with acyclic and preorganized bicyclic malonamide ligands. Two experimental investigations were performed: solution binding affinities were determined through single-phase spectrophotometric titrations and the extent of conformational change upon binding was investigated with single-crystal X-ray crystallography. Both experimental methods compare the bicyclic malonamide (BMA), which is designed to be preorganized for binding trivalent lanthanides, to an analogous acyclic malonamide. Results from the spectrophotometric titrations indicate that BMA exhibits a 10-100x increase in binding affinity to Ln(III) over acyclic malonamide. In addition, BMA forms compounds with high ligand-metal ratios, even when competing with water and nitrate ligands for binding sites. The crystal structures exhibit no significant differences in the nature of the binding between Ln(III) and the BMA or acyclic malonamide. These results support the conclusion that rational ligand design can lead to compounds that enhance the binding affinities within a ligand class.

A general synthetic approach was developed for the preparation of a series of 6,6-bicyclic malonamides, a class of ligands that provide a preorganized binding site for f-block ions (particularly trivalent lanthanides). The approach described is convenient to introduce a variety of functional groups at the amide nitrogens to tune the properties of the ligand without altering the preorganized binding. Each of the ten derivatives (that represent a range of functionality, including R = alkyl, hydroxy, phenyl, ester, perfluorocarbon) reported here derives from a single, readily prepared dialdehyde intermediate. This intermediate is converted to the final products via reductive amination with an appropriately functionalized benzylamine, followed by hydrogenolysis and lactam formation. Because derivatization occurs late in the synthesis, the approach is general, requiring only modification of the purification procedures for each new derivative. To aid in the purification of the bicyclic malonamides, we report a novel complexation-based purification method that takes advantage of the high affinity of the ligand for f-block metals.