Fully bio-and CO 2 -sourced non-isocyanate polyurethanes (NIPUs) were synthesized by reaction of carbonated soybean oil (CSBO) either with biobased short diamines or amino-telechelic oligoamides derived from fatty acids to achieve respectively thermoset or thermoplastic NIPUs. Biobased carbonated vegetable oils were first obtained by metal-free coupling reactions of CO 2 with epoxidized soybean oils under supercritical conditions (120 °C, 100 bar) before complete characterization by FTIR, 1 H NMR, and electrospray ionization mass spectroscopy (ESI-MS). In a second step, biobased NIPUs were produced by melt-blending of the so-produced cyclocarbonated oil with the biobased aminated derivatives. The thermal and mechanical properties of resulting polymers were found to be depending on the cyclocarbonated vegetable oil/amine ratio. More precisely, short diamines and CSBO led to the formation of cross-linked NIPUs, and the resulting tensile and thermal properties were poor. In contrast, elastomeric NIPUs derived from oligoamides and CSBO exhibited a better rigidity, an improved elongation at break (ε r up to 400%), and a higher thermal stability (T 95 wt % > 350 °C) than those of starting oligoamides. These results are impressive and highlight the potentiality of this environmental friendly approach to prepare renewable NIPU materials of high performances.

No abstract

No abstract

In this paper, TiO2 prepared with an aqueous sol-gel synthesis by peptization process is doped with nitrogen precursor to extend its activity towards the visible region. Three N-precursors are used: urea, ethylenediamine and triethylamine. Different molar N/Ti ratios are tested and the synthesis is adapted for each dopant. For urea- and trimethylamine-doped samples, anatase-brookite TiO2 nanoparticles of 6–8 nm are formed, with a specific surface area between 200 and 275 m2·g−1. In ethylenediamine-doped samples, the formation of rutile phase is observed, and TiO2 nanoparticles of 6–8 nm with a specific surface area between 185 and 240 m2·g−1 are obtained. X-ray photoelectron spectroscopy (XPS) and diffuse reflectance measurements show the incorporation of nitrogen in TiO2 materials through Ti–O–N bonds allowing light absorption in the visible region. Photocatalytic tests on the remediation of water polluted with p-nitrophenol show a marked improvement for all doped catalysts under visible light. The optimum doping, taking into account cost, activity and ease of synthesis, is up-scaled to a volume of 5 L and compared to commercial Degussa P25 material. This up-scaled sample shows similar properties compared to the lab-scale sample, i.e., a photoactivity 4 times higher than commercial P25.

No abstract

No abstract

No abstract

No abstract