Improved assays for the molybdenum enzyme dimethylsulfoxide reductase (DMSOR) with dimethyl sulfoxide (DMSO) and with dimethyl sulfide (DMS) as substrates are described. Maximum activity was observed at pH 6.5 and below and at 8.3, respectively. Rapid-scan stopped-flow spectrophotometry has been used to investigate the reduction of the enzyme by DMS to a species previously characterized by its UV-visible spectrum [McAlpine, A. S., McEwan, A. G., and Bailey, S. (1998) J. Mol. Biol. 275, 613-623], and its subsequent reoxidation by DMSO. Both these two-electron reactions were faster than enzyme turnover under steady-state conditions, indicating that one-electron reactions with artificial dyes were rate-limiting. Second-order rate constants for the two-electron reduction and reoxidation reactions at pH 5.5 were (1.9 +/- 0.1) x 10(5) and (4.3 +/- 0.3) x 10(2) M-1 s-1, respectively, while at pH 8.0, the catalytic step was rate-limiting (62 s-1). Kinetically, for the two-electron reactions, the enzyme is more effective in DMS oxidation than in DMSO reduction. Reduction of DMSOR by DMS was incomplete below approximately 1 mM DMS but complete at higher concentrations, implying that the enzyme's redox potential is slightly higher than that of the DMS-DMSO couple. In contrast, reoxidation of the DMS-reduced state by DMSO was always incomplete, regardless of the DMSO concentration. Evidence for the existence of a spectroscopically indistinguishable reduced state, which could not be reoxidized by DMSO, was obtained. Brief reaction (less than approximately 15 min) of DMS with DMSOR was fully reversible on removal of the DMS. However, in the presence of excess DMS, a further slow reaction occurred aerobically, but not anaerobically, to yield a stable enzyme form having a lambdamax at 660 mn. This state (DMSORmod) retained full activity in steady-state assays with DMSO, but was inactive toward DMS. It could however be reconverted to the original resting state by reduction with methyl viologen radical and reoxidation with DMSO. We suggest that in this enzyme form two of the dithiolene ligands of the molybdenum have dissociated and formed a disulfide. The implications of this new species are discussed in relation both to conflicting published information for DMSOR from X-ray crystallography and to previous spectroscopic data for its reduced forms.

Much is unknown concerning the role of thiolate ligands of molybdenum in molybdopterin enzymes. It has been suggested that thiolate dissociation from molybdenum is part of the catalytic mechanism of bis-molybdopterin enzymes of the dimethyl sulfoxide reductase (DMSOR) family. For DMSOR from Rhodobacter capsulatus, thiolate dissociation has therefore been investigated crystallographically, by UV/visible spectroscopy, and by enzyme assays. When crystallized from sodium citrate, all four thiolates of DMSOR are within bonding distance of Mo, but after extended exposure to Na(+)-Hepes, a pair of thiolates dissociates, a mixture of structures being indicated after shorter exposures to this buffer. DMSOR is stable in sodium citrate and other buffers but unstable aerobically although not anaerobically in Na(+)-Hepes. Aerobically in Na(+)-Hepes, a first-order reaction (k = 0.032 hr(-)(1) at 37 degrees C) leads to loss of activity in the backward but not the forward (dimethyl sulfoxide reduction) assay and loss of absorption at lambda > approximately 450 nm. This reaction can be reversed by a cycle of reduction and reoxidation ("redox-cycling"). Slower irreversible loss of activity in the forward assay and cofactor dissociation follow. Spectral analogy with a mono-molybdopterin enzyme supports the conclusion that in the Hepes-modified DMSOR form, only two cofactor dithiolene sulfur atoms are coordinated to molybdenum. Loss of activity provides the first clear evidence that sulfur ligand dissociation is an artifact, not part of the catalytic cycle. Clearly, structural data on DMSOR samples extensively exposed to Hepes is not directly relevant to the native enzyme. The nature of the oxygen ligands detected crystallographically is discussed, as is the specificity of Hepes and the mechanism whereby its effects are achieved. DMSOR forms complexes with Na(+)-Hepes and other buffer ions. For DMSOR crystallized from Hepes, electron density in the substrate binding channel suggests that buffers bind in this site. Like the as-prepared enzyme, the modified form (DMSOR(mod)D), known to arise on extended aerobic exposure to dimethyl sulfide, is susceptible to a further degradative reaction, although this is not buffer-dependent. It involves loss of absorption at lambda > approximately 450 nm and, presumably, dissociation of thiolate ligands. Evidence is presented that, as a result of O(2) damage, DMSOR samples not submitted to redox-cycling may be contaminated with DMSOR(mod)D and with material absorbing in the region of 400 nm, analogous to the Hepes-modified enzyme. Since the latter lacks absorption at lambda > approximately 450 nm, its presence may escape detection.