No abstract

This paper analyses the effect of vegetation on wave damping under severe storm conditions, based on a combination of field measurements and numerical modelling. The field measurements of wave attenuation by vegetation were performed on two salt marshes with two representative but contrasting coastal wetland vegetation types: cordgrass (Spartina anglica) and grassweed (Scirpus maritimus). The former is found in salty environments, whereas the latter is found in brackish environments. The measurements have added to the range with the highest water depths and wave heights presented in the literature so far. A numerical wave model (SWAN) has been calibrated and validated using the new field data. It appeared that the model was well capable of reproducing the observed decay in wave height over the salt marsh. The model has been applied to compute the reduction of the incident wave height on a dike for various realistic foreshore configurations and hydraulic loading conditions. Additionally, the efficiency of vegetated foreshores in reducing wave loads on the dike has been investigated, where wave loads were quantified using a computed wave run-up height and wave overtopping discharge. The outcomes show that vegetated foreshores reduce wave loads on coastal dikes significantly, also for the large inundation depths that occur during storms and with the vegetation being in winter state. The effect of the foreshore on the wave loads varies with wave height to water depth ratio on the foreshore. The presence of vegetation on the foreshore extends the range of water depths for which a foreshore can be applied for effective reduction of wave loads, and prevents intense wave breaking on the foreshore to occur. This research demonstrates that vegetated foreshores can be considered as a promising supplement to conventional engineering methods for dike reinforcement.

One of the services provided by coastal ecosystems is wave attenuation by vegetation, and subsequent reduction of wave loads on flood defense structures. Therefore, stability of vegetation under wave forcing is an important factor to consider. This paper presents a model which determines the wave load that plant stems can withstand before they break or fold. This occurs when wave-induced bending stresses exceed the flexural strength of stems. Flexural strength was determined by means of three-point-bending tests, which were carried out for two common salt marsh species: Spartina anglica (common cord-grass) and Scirpus maritimus (sea club-rush), at different stages in the seasonal cycle. Plant stability is expressed in terms of a critical orbital velocity, which combines factors that contribute to stability: high flexural strength, large stem diameter, low vegetation height, high flexibility and a low drag coefficient. In order to include stem breakage in the computation of wave attenuation by vegetation, the stem breakage model was implemented in a wave energy balance. A model parameter was calibrated so that the predicted stem breakage corresponded with the wave-induced loss of biomass that occurred in the field. The stability of Spartina is significantly higher than that of Scirpus, because of its higher strength, shorter stems, and greater flexibility. The model is validated by applying wave flume tests of Elymus athericus (sea couch), which produced reasonable results with regards to the threshold of folding and overall stem breakage percentage, despite the high flexibility of this species. Application of the stem breakage model will lead to a more realistic assessment of the role of vegetation for coastal protection.