The aim of this work was to develop an immunoassay-based lateral flow dipstick for the rapid detection of aflatoxin B(1) in pig feed. The test consisted of three main components: conjugate pad, membrane, and absorbent pad. The membrane was coated with two capture reagents, that is, aflatoxin B(1)-bovine serum albumin conjugate and rabbit anti-mouse antibodies. The detector reagent consisted of colloidal gold particles coated with affinity-purified monoclonal anti-aflatoxin B(1) antibodies, which saturated the conjugate pad. A comparison of several extraction methods for the pig feed matrix is presented. A mixture of methanol/water (80:20, v/v) gave the best recoveries. After sample extraction and dilution, the dipstick was put in the sample solution at the conjugate pad side and developed for 10 min. Analyte present in the sample competed with the aflatoxin B(1) immobilized on the membrane for binding to the limited amount of antibodies in the detector reagent. Thus, the line color intensity of an aflatoxin B(1)-positive dipstick is visually distinguishable from that of an aflatoxin B(1)-negative sample. The visual detection limit for aflatoxin B(1) is 5 microg/kg. The major advantages of this one-step striptest are that results can be obtained within 10 min and that all reagents are immobilized on the lateral flow dipstick.

Concerns have been raised about exposure to mycotoxin producing fungi and the microbial volatile organic compounds (MVOCs) they produce in indoor environments. Therefore, the presence of fungi and mycotoxins was investigated in 99 samples (air, dust, wallpaper, mycelium or silicone) collected in the mouldy interiors of seven water-damaged buildings. In addition, volatile organic compounds (VOCs) were sampled. The mycotoxins were analysed by liquid chromatography-tandem mass spectrometry (LC-MS/MS) (20 target mycotoxins) and quadrupole time-of-flight mass spectrometry (LC-Q-TOF-MS). Morphological and molecular identifications of fungi were performed. Of the 99 samples analysed, the presence of one or more mycotoxins was shown in 62 samples by means of LC-MS/MS analysis. The mycotoxins found were mainly roquefortine C, chaetoglobosin A and sterigmatocystin but also roridin E, ochratoxin A, aflatoxin B(1) and aflatoxin B(2) were detected. Q-TOF-MS analysis elucidated the possible occurrence of another 42 different fungal metabolites. In general, the fungi identified matched well with the mycotoxins detected. The most common fungal species found were Penicillium chrysogenum, Aspergillus versicolor (group), Chaetomium spp. and Cladosporium spp. In addition, one hundred and seventeen (M)VOCs were identified, especially linear alkanes (C(9)-C(17)), aldehydes, aromatic compounds and monoterpenes.

The development of a liquid chromatography/tandem mass spectrometry (LC/MS/MS) method for the simultaneous determination of 16 mycotoxins possibly related to the 'Sick Building Syndrome' on filters and in fungal cultures is described. Fungi-surface sampling as regards the 'Sick Building Syndrome' preferably happens by scraping off fungal material and vacuuming onto cellulose filters. Therefore, these two media were used as samples. They were spiked with nivalenol, deoxynivalenol, zearalenone, diacetoxyscirpenol, T-2 toxin, verrucarol, verrucarin A, neosolaniol, sterigmatocystin, roridin A, ochratoxin A, aflatoxin B1, aflatoxin B2, aflatoxin G1 and aflatoxin G2, which can be produced by isolates from fungi-damaged buildings. Deepoxy-deoxynivalenol was used as internal standard. Samples were extracted with organic solvents and the different mycotoxins were separated by high-performance liquid chromatography (HPLC) using a C18 reversed-phase SunFire analytical column and a mobile phase of variable mixtures of ammonium acetate (10 mM) and sodium acetate (20 microM) in water (solvent A) and in methanol (solvent B). The samples were run on-line with a Micromass Quattro Micro triple quadrupole mass spectrometer in positive electrospray ionisation mode using multiple reaction monitoring (MRM). The detection limits of the procedure varied from 50 to 0.009 pg/microL for filter samples and from 75 to 0.04 pg/microL for fungal culture samples. As the method includes few and non-labourious sample treatment steps, it should allow for a high throughput of samples.

An automated headspace solid phase microextraction method followed by GC-MS analysis was used to evaluate and compare the in vitro production of microbial volatile organic compounds (MVOCs) on malt extract agar, plasterboard and wallpaper. Five fungal strains were isolated from the walls of water-damaged houses and identified. In addition, four other common molds were studied. In general, MVOC production was the highest on malt extract agar. On this synthetic medium, molds typically produced 2-methylpropanol, 2-methylbutanol and 3-methylbutanol. On wallpaper, mainly 2-ethylhexanol, methyl 2-ethylhexanoate and compounds of the C8-complex such as 1-octene-3-ol, 3-octanone, 3-octanol and 1,3-octadiene were detected. The detection of 2-ethylhexanol and methyl 2-ethylhexanoate indicates an enhanced degradation of the substrate by most fungi. For growth on plasterboard, no typical metabolites were detected. Despite these metabolite differences on malt extract agar, wallpaper and plasterboard, some molds also produced specific compounds independently of the used substrate, such as trichodiene from Fusarium sporotrichioides and aristolochene from Penicillium roqueforti. Therefore, these metabolites can be used as markers for the identification and maybe also mycotoxin production of these molds. All five investigated Penicillium spp. in this study were able to produce two specific diterpenes, which were not produced by the other species studied. These two compounds, which remain unidentified until now, therefore seem specific for Penicillium spp. and are potentially interesting for the monitoring of this fungal genus. Further experiments will be performed with other Penicillium spp. to study the possibility that these two compounds are specific for this group of molds.