The safe and effective delivery of RNA interference (RNAi) therapeutics remains an important challenge for clinical development. The diversity of current delivery materials remains limited, in part because of their slow, multi-step syntheses. Here we describe a new class of lipid-like delivery molecules, termed lipidoids, as delivery agents for RNAi therapeutics. Chemical methods were developed to allow the rapid synthesis of a large library of over 1,200 structurally diverse lipidoids. From this library, we identified lipidoids that facilitate high levels of specific silencing of endogenous gene transcripts when formulated with either double-stranded small interfering RNA (siRNA) or single-stranded antisense 2'-O-methyl (2'-OMe) oligoribonucleotides targeting microRNA (miRNA). The safety and efficacy of lipidoids were evaluated in three animal models: mice, rats and nonhuman primates. The studies reported here suggest that these materials may have broad utility for both local and systemic delivery of RNA therapeutics.

There is a significant medical need for tough biodegradable polymer adhesives that can adapt to or recover from various mechanical deformations while remaining strongly attached to the underlying tissue. We approached this problem by using a polymer poly(glycerol-co-sebacate acrylate) and modifying the surface to mimic the nanotopography of gecko feet, which allows attachment to vertical surfaces. Translation of existing gecko-inspired adhesives for medical applications is complex, as multiple parameters must be optimized, including: biocompatibility, biodegradation, strong adhesive tissue bonding, as well as compliance and conformability to tissue surfaces. Ideally these adhesives would also have the ability to deliver drugs or growth factors to promote healing. As a first demonstration, we have created a gecko-inspired tissue adhesive from a biocompatible and biodegradable elastomer combined with a thin tissue-reactive biocompatible surface coating. Tissue adhesion was optimized by varying dimensions of the nanoscale pillars, including the ratio of tip diameter to pitch and the ratio of tip diameter to base diameter. Coating these nanomolded pillars of biodegradable elastomers with a thin layer of oxidized dextran significantly increased the interfacial adhesion strength on porcine intestine tissue in vitro and in the rat abdominal subfascial in vivo environment. This gecko-inspired medical adhesive may have potential applications for sealing wounds and for replacement or augmentation of sutures or staples.chemical cross-link ͉ medical adhesive ͉ nanotopography ͉ surgical suture

Elastomeric networks are increasingly being investigated for a variety of biomedical applications including drug delivery and tissue engineering. However, in some cases, their preparation requires the use of harsh processing conditions (e.g., high temperature), which limits their biomedical application. Herein, we demonstrate the ability to form elastomeric networks from poly(glycerol-co-sebacate) acrylate (PGSA) under mild conditions while preserving a wide range of physical properties. These networks presented a Young's modulus between 0.05 and 1.38 MPa, an ultimate strength from 0.05 to 0.50 Mpa, and elongation at break between 42% and 189% strain, by varying the degree of acrylation (DA) of PGSA. The in vitro enzymatic and hydrolytic degradation of the polymer networks was dependent on the DA. The copolymerization of poly(ethylene glycol) diacrylate with PGSA allowed for an additional control of mechanical properties and swelling ratios in an aqueous environment, as well as enzymatic and hydrolytic degradation. Photocured PGSA networks demonstrated in vitro biocompatibility as judged by sufficient human primary cell adherence and subsequent proliferation into a confluent monolayer. These photocurable degradable elastomers could have potential application for the encapsulation of temperature-sensitive factors and cells for tissue engineering.