Hard carbons have shown considerable promise as anodes for emerging sodium-ion battery technologies. Current understanding of sodium-storage behaviour in hard carbons attributes capacity to filling of graphitic interlayers and pores,...

A series of hard-soft carbon composite materials is produced from biomass and oil waste and applied as low-cost anodes for sodium-ion batteries to study the fundamentals behind the dependence of Na storage on their structural features. A good reversible capacity of 282 mAh g −1 is obtained at a current density of 30 mA g −1 with a high initial Coulombic efficiency of 80% at a carbonization temperature of only 1000 °C by adjusting the ratio of hard to soft carbon. The performance is superior to the pure hard or soft carbon anodes produced at the same temperatures. This synergy between hard and soft carbon resulting in an excellent performance is due to the blockage of some open pores in hard carbon by the soft carbon, which suppresses the solid electro lyte interface formation and increases the reversible sodium storage capacity.

Porous structure design is generally considered to be a reliable strategy to boost ion transport and provide active sites for disordered carbon anodes of Na‐ion batteries (NIBs). Herein, a type of waste cork‐derived hard carbon material (CC) is reported for efficient Na storage via tuning the pore species. Benefiting from the natural holey texture of this renewable precursor, CCs deliver a novel hierarchical porous structure. The effective skeletal density test combined with small angle X‐ray scattering analysis (SAXS) is used to obtain the closed pore information. Based on a detailed correlation analysis between pore information and the electrochemical performance of CCs, improving pyrolysis temperature to reduce open pores (related to initial capacity loss) and increase closed pores (related to plateau capacity) endows an optimal CC with a high specific capacity of ≈360 mAh g−1 in half‐cells and a high energy density of 230 Wh kg−1 in full‐cells with a capacity retention of 71% after 2000 cycles at 2C rate. The bioinspired high temperature pore‐closing strategy and the new insights about the pore structure–performance relationship provide a rational guide for designing porous carbon anode of NIBs with tailored pore species and high Na storage capacity.

Calcium carbonate is a common constituent of many natural materials, such as shells and skeletons of marine animals. While it is well-documented that additives (organic and inorganic) modulate the crystallization of amorphous calcium carbonate (ACC), the effects of the intrinsic physicochemical characteristics of ACC, such as particle size, shape, and water content on the transformation to crystalline polymorphs, are still poorly understood. Here, we investigate the effect of particle size by preparing ACC nanoparticles with an average size ranging from ∼66 to ∼196 nm using a highresolution titration setup. Our results show that the particle size determined the polymorph selection in solution; an increasing proportion of vaterite to calcite was observed with decreasing particle size. The polymorph selection was ascribed to a higher apparent solubility of ACC with decreasing particle size, a parameter from which we could determine the surface energy of ACC to be ∼0.33 J/m 2 . Upon heating, particle size showed the opposite effect, as smaller particles favored a higher crystallization temperature from ACC into (only) calcite. When the particle size was large enough, crystallization occurred concomitantly with the removal of bulk water at lower temperatures, where the smallest particles transformed at ∼310°C, only after losing the final (surface) water. Our results highlight the importance of particle size as well as the crystallization conditions on the stability and transformation mechanisms of ACC.