The main principle of vibration-based damage detection in structures is to interpret the changes in dynamic properties of the structure as indicators of damage. In this study, the mode shape damage index (MSDI) method was used to identify discrete damages in plate-like structures. This damage index is based on the difference between modified modal displacements in the undamaged and damaged state of the structure. In order to assess the advantages and limitations of the proposed algorithm, we performed experimental modal analysis on a reinforced concrete (RC) plate under 10 different damage cases. The MSDI values were calculated through considering single and/or multiple damage locations, different levels of damage, and boundary conditions. The experimental results confirmed that the MSDI method can be used to detect the existence of damage, identify single and/or multiple damage locations, and estimate damage severity in the case of single discrete damage.
This study presents a complex experimental research of a damaged steel railway bridge. Before the reconstruction, the elastic behavior of the material was evaluated using the hole-drilling strain gauge method of determining residual stresses at the relevant cross-sections. During the reconstruction project (lifting of the structure), a short-term monitoring system was installed at the critical cross-sections for continuous recording of strain. The aim was to evaluate the quality of the reconstruction intervention and prevent further damages. Following a successful reconstruction, a diagnostic load testing was performed according to Croatian standards. The purpose of the load testing (static and dynamic) was to evaluate the ability of the bridge to carry the design loads and calibrate the finite element models. During static load testing vertical displacement was measured as well as strain. Dynamic load testing of the bridge was performed in order to determine the main dynamic parameters of the structure and to calculate the dynamic factor. In order to select the appropriate measurement parameters and methods used during this experimental research it was necessary to consider the bridge type, materials and reconstruction or strengthening interventions. Especially, since this bridge was an example of insufficient inspection and maintenance during service. A well-designed monitoring and diagnostic load testing needed to be performed in order to obtain useful results for the decision makers involved.
In finite element analysis of steel‐reinforced elastomeric bearings (SREB) under compression, modeling of rubber as a nearly or fully incompressible material requires special attention. In this study, finite element simulations of circular elastomeric pads and rectangular SREB under compression were performed to analyze the effects of rubber compressibility with respect to different pad geometries and shape factor values. The ratio of the compressive modulus for a compressible rubber to that of an incompressible rubber was also introduced based on the previously derived exact solutions as well as the ad hoc approximations. This ratio accurately represents the influence of compressibility on compressive stiffness in terms of relative compressibility (K/G) and shape factor values. Numerical results were also compared with the experimental results on rectangular SREB with moderate shape factors. Recommended values for relative compressibility of carbon black‐filled rubbers in the range of 50–200 result in underestimated compressive stiffness, especially for bearings with shape factor values greater than five. It is recommended to adjust the relative compressibility, considering the shape factor, so that the compressive stiffness does not decrease by more than 50% compared to the incompressible case.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.