Novel antibacterial agents are needed to address the emergence of global antibiotic resistance. MraY is a promising candidate for antibiotic development because it is the target of five classes of naturally occurring nucleoside inhibitors with potent antibacterial activity. Although these natural products share a common uridine moiety, their core structures vary substantially and they exhibit different activity profiles. An incomplete understanding of the structural and mechanistic basis of MraY inhibition has hindered the translation of these compounds to the clinic. Here we present crystal structures of MraY in complex with representative members of the liposidomycin/caprazamycin, capuramycin, and mureidomycin classes of nucleoside inhibitors. Our structures reveal cryptic druggable hot spots in the shallow inhibitor binding site of MraY that were not previously appreciated. Structural analyses of nucleoside inhibitor binding provide insights into the chemical logic of MraY inhibition, which can guide novel approaches to MraY-targeted antibiotic design.

The effect of the solvent on the diastereoselectivity of the Joullié-Ugi three-component reaction (JU-3CR) using an α-substituted five-membered cyclic imine is revisited. The cis and trans isomers were generated in toluene and HFIP, respectively. Hammett analysis of the JU-3CR suggests the presence of two reaction mechanisms.

The total synthesis of plusbacin A (1) has been accomplished using a solvent-dependent diastereodivergent Joullié-Ugi three-component reaction (JU-3CR) as a key step. Two trans-3-hydroxy-l-proline residues were constructed by combining the JU-3CR with a convertible isocyanide strategy. Subsequent peptide coupling and macrolactamization afforded plusbacin A. Investigating the antibacterial activity of 1 compared with that of its dideoxy analogue revealed that the threo-β-hydroxyaspartic acid residues are essential for antibacterial activity. Notably, there is a low potential for the development of resistance in S. aureus against plusbacin A.

Full details of our synthetic studies toward plusbacin A (1), which is a depsipeptide with antibacterial activity, and its dideoxy derivative are described. To establish an efficient synthetic route of 1, a solvent-dependent diastereodivergent Joullié-Ugi three-component reaction (JU-3CR) was used to construct trans-Pro(3-OH) in a small number of steps. Two strategies were investigated toward the total synthesis. In the first synthetic strategy, the key steps were the trans-selective JU-3CR and a macrolactonization at the final stage of the synthesis. The JU-3CR using alkyl isocyanides in 1,1,1,3,3,3-hexafluoroisopropanol provided the trans products, and the coupling of the fragments to prepare the macrocyclization precursor proceeded smoothly. However, attempts toward the macrolactonization did not provide the desired product. Then, the second strategy that included esterification in an initial stage was investigated. Methods for constructing trans-Pro(3-OH) were examined using a convertible isocyanide, which could be converted to a carboxylic acid required for the following amidation. Ester bond formation was achieved through an intermolecular coupling using a hydroxyl-Asp derivative and the corresponding alcohol, and the amidation afforded a linear depsipeptide. The macrolactamization of the linear peptide gave the cyclic depsipeptide, and then the global deprotection accomplished the total synthesis of 1 and its dideoxy derivative.

A solid-phase synthesis of Park nucleotide as well as lipids I and II analogues, which is applicable to the synthesis of a range of analogues, is described in this work. This technique allows highly functionalized macromolecules to be modularly labeled. Multiple steps are used in a short time (4 d) with a single purification step to synthesize the molecules by solid-phase synthesis.