The main purpose of this study is the selection of a proper fabric for the reference clothing for ergonomic tests of protective clothing. For research, seven fabric of different raw material content and different structure were chosen. We studied the handle of fabrics produced from blend of polyester/cotton and polyester/Tencel, which were designated by letters from A to G. The assessment of handle of the fabric was performed based on the mechanical properties of fabrics using Kawabata evaluation system (KES-system). It was proven that one of the tested fabrics (F) made of polyester and cotton fibers (85% PES / 15% cotton) with the reinforced twill weave is characterized by the highest total hand value (THV).The high THV results from the low value of koshi (stiffness) and the highest value of numeri (smoothness) and fukurami (fullness). However, in terms of physiological comfort, the lower value of fukurami is more preferred. It turned out that the fabric with the higher value of fukurami (including fabric F) is characterized by the lower air permeability and higher water vapor resistance. At the end, we decided that the reference clothing will be made of cotton/polyester fabric G with the lowest mass per square meter because of the very good physiological comfort parameters and the satisfactory sensorial comfort parameters.

No abstract

Behavior of woven fabrics during complex deformations is most influentially affected by their shear behavior. Shear characteristics of woven fabrics can be explained by fabric shear rigidity and shear hysteresis. In this study, the effects of weft density, weft count, and fiber type on shear behavior of woven fabrics in the principal directions of fabric were statistically evaluated. Statistical methods such as multiple linear regression analysis, univariate test, and correlation analysis were also applied. The univariate test results confirmed that the weft density is the most dominant parameter that affects fabric shear properties. Multiple linear regression results point to poor shear behavior in woven fabrics with cotton weft yarns. In addition, correlation between the shear rigidity of the fabrics along principal directions with the Milasius fabric firmness factor and the fabric cover factor as integrated structural parameters was established. High correlation was found to exist among Milasius fabric firmness factor, fabric cover factor, and shear rigidity of fabrics along principal directions.

In response to the demand for new implant materials characterized by high biocompatibility and bioresorption, two prototypes of fibrous nanocomposite implants for osseous tissue regeneration made of a newly developed blend of poly(l-lactide-co-glycolide) (PLGA) and syntheticpoly([R,S]-3-hydroxybutyrate), PLGA/PHB, have been developed and fabricated. Afibre-forming copolymer of glycolide and l-lactide (PLGA) was obtained by a unique method of synthesis carried out in blocksusing Zr(AcAc)4 as an initiator. The prototypes of the implants are composed of three layers of PLGA or PLGA/PHB, nonwoven fabrics with a pore structure designed to provide the best conditions for the cell proliferation. The bioactivity of the proposed implants has been imparted by introducing a hydroxyapatite material and IGF1, a growth factor. The developed prototypes of implants have been subjected to a set of in vitro and in vivobiocompatibility tests: in vitro cytotoxic effect, in vitro genotoxicity and systemic toxicity. Rabbitsshowed no signs of negative reactionafter implantation of the experimental implant prototypes.