Formaldehyde (HCHO) is an important indicator of indoor air quality and one of the markers for detecting lung cancer. Both medical and air quality applications require the detection of formaldehyde in the sub-ppm range. Nanocomposites SnO2/TiO2 are promising candidates for HCHO detection, both in dark conditions and under UV illumination. Nanocomposites TiO2@SnO2 were synthesized by ALD method using nanocrystalline SnO2 powder as a substrate for TiO2 layer growth. The microstructure and composition of the samples were characterized by ICP-MS, TEM, XRD and Raman spectroscopy methods. The active surface sites were investigated using FTIR and TPR-H2 methods. The mechanism of formaldehyde oxidation on the surface of semiconductor oxides was studied by in situ DRIFTS method. The sensor properties of nanocrystalline SnO2 and TiO2@SnO2 nanocomposites toward formaldehyde (0.06–0.6 ppm) were studied by in situ electrical conductivity measurements in dark conditions and under periodic UV illumination at 50–300 °C. Nanocomposites TiO2@SnO2 exhibit a higher sensor signal than SnO2 and a decrease in the optimal measurement temperature by 50 °C. This result is explained based on the model considering the formation of n-n heterocontact at the SnO2/TiO2 interface. UV illumination leads to a decrease in sensor response compared with that obtained in dark conditions because of the photodesorption of oxygen involved in the oxidation of formaldehyde.
In this work, the hybrids based on nanocrystalline SnO2 or In2O3 semiconductor matrixes and heterocyclic Ru(II) complex are studied as materials for gas sensors operating at room temperature under photoactivation with visible light. Nanocrystalline semiconductor oxides are obtained by chemical precipitation with subsequent thermal annealing and characterized by XRD, SEM and single-point BET methods. The heterocyclic Ru(II) complex is synthesized for the first time and investigated by 1H NMR, 13C NMR APT, MALDI-MS analysis, and UV-Vis spectroscopy. The HOMO and LUMO energies of the Ru(II) complex are calculated from cyclic voltammetry data. The hybrid materials are characterized by TGA-MS analysis and EDX mapping. The optical properties of hybrids are studied by UV-Vis spectroscopy in the diffuse reflection mode. The investigation of spectral dependencies of photoconductivity of hybrid samples demonstrates that the role of organic dye consists in shifting the photosensitivity range towards longer wavelengths. Sensor measurements demonstrate that hybrid materials are able to detect NO2 in the concentration range of 0.25–2 ppm without the use of thermal heating under periodic illumination with even low-energy long-wavelength (red) light.
Air humidity is one of the main factors affecting the characteristics of semiconductor gas sensors, especially at low measurement temperatures. In this work we analyzed the influence of relative humidity on sensor properties of the hybrid materials based on the nanocrystalline SnO2 and In2O3 and Ru (II) heterocyclic complex and verified the possibility of using such materials for NO (0.25–4.0 ppm) and NO2 (0.05–1.0 ppm) detection in high humidity conditions (relative humidity (RH) = 20%, 40%, 65%, 90%) at room temperature during periodic blue (λmax = 470 nm) illumination. To reveal the reasons for the different influence of humidity on the sensors’ sensitivity when detecting NO and NO2, electron paramagnetic resonance (EPR) spectroscopy and diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) investigations were undertaken. It was established that the substitution of adsorbed oxygen by water molecules causes the decrease in sensor response to NO in humid air. The influence of humidity on the interaction of sensitive materials with NO2 is determined by the following factors: the increase in charge carrier’s concentration, the decrease in the number of active sites capable of interacting with gases, and possible substitution of chemisorbed oxygen with NO2− groups.
Nitric oxide (NO) is one of the main environmental pollutants and one of the biomarkers noninvasive diagnosis of respiratory diseases. Organic-inorganic hybrids based on heterocyclic Ru (II) complex and nanocrystalline semiconductor oxides SnO 2 and In 2 O 3 were studied as sensitive materials for NO detection at room temperature under periodic blue light (λ max = 470 nm) illumination. The semiconductor matrixes were obtained by chemical precipitation with subsequent thermal annealing and characterized by XRD, Raman spectroscopy, and single-point BET methods. The heterocyclic Ru (II) complex was synthesized for the first time and characterized by 1 H NMR, 13 C NMR, MALDI-TOF mass spectrometry and elemental analysis. The HOMO and LUMO energies of the Ru (II) complex are calculated from cyclic voltammetry data. The thermal stability of hybrids was investigated by thermogravimetric analysis (TGA)-MS analysis. The optical properties of Ru (II) complex, nanocrystalline oxides and hybrids were studied by UV-Vis spectroscopy in transmission and diffuse reflectance modes. DRIFT spectroscopy was performed to investigate the interaction between NO and the surface of the synthesized materials. Sensor measurements demonstrate that hybrid materials are able to detect NO at room temperature in the concentration range of 0.25-4.0 ppm with the detection limit of 69-88 ppb.Nanomaterials 2020, 10, 70 2 of 22 in noninvasive diagnosis of respiratory diseases [7][8][9]. In this case, the limitation of the quantitative determination of NO in exhaled air is due to the low level of its concentration (20-200 ppb) among a wide range of interfering gases [10].Direct determination of nitrogen monoxide in the gas phase is possible using conductometric gas sensors based on various semiconductor metal oxides [7,[10][11][12][13][14][15][16][17][18][19][20][21][22]. To increase selectivity of such analysis along with lower power consumption, complete or partial replacement of thermal heating with photoactivation is a promising approach. Activation of the sensor response under illumination occurs through various mechanisms depending on the nature of the target gas. For oxidizing gases (NO 2 , O 3 ), which compete with oxygen for the same adsorption sites, photogeneration of electron-hole pairs plays a major role in the photodesorption process. On the contrary, for the detection of reducing gases (CO, NH 3 , H 2 S), the presence of chemisorbed oxygen on the surface of the semiconductor oxide is necessary. In this case, the increase in the sensor response under illumination is due to the unpinning of Fermi level of the semiconductor. In most works NO is detected as oxidizing gas. The similar routes of NO and NO 2 sensing was recently evidenced by in situ DRIFT spectroscopy [23]. Our previous works show that highly selective NO 2 detection is possible using visible light photoactivation [24][25][26][27]. To shift the optical sensitivity of semiconductor oxides into the visible range, it is necessary to create defects in the semiconductor matrix or i...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.