The aim of this study was to investigate the properties of an organic binder used in cold-bonded briquettes (CBBs) prepared from two different iron bearing materials. The applied binder is a type of starch as indicated by chemical analysis, iodine-starch staining and Fourier transform infrared analyses. Thermogravimetric differential scanning calorimetry showed that the binder pyrolysis undergoes four stages: moisture desorption, ash volatilization, pyrolysis of organic matter and decomposition of materials with high activation energy. The difference between the dry and heat-treated samples during the macroscopic failure process is the instability propagation of the crack. The CBB shows a low decrepitation index at 700 °C. The returned fines of CBBs used with the organic binder were applied in two blast furnaces. The industrial trials showed that the CBBs do not influence the performance of the blast furnace and can reduce the fuel consumption rate. The curing rate of the binder decreases, and the growth rate of compressive strength decreases during the curing process. Iron ore particles are bonded together and exist in the form of aggregation after mixing with water and binder. The edges and corners of the particles become blurred, and the original surfaces of the particles are covered with binder film, the surface of which is covered with fine particles. The multi-branched structure of amylopectin provides omnibearing adhesion sites, thus forming binder agglomeration and film leading to a strong adhesion between binder and iron ore particles. Binder film and binder agglomeration work together to make the CBB perform well.
Iron ore fines was isothermally and non-isothermally reduced with CO and the total mass loss was continuously recorded. The different phases developed during the reduction process were identified by X-ray diffraction analysis. The structural changes accompanying the reduction reactions were microscopically examined. During the isothermal reduction tests, temperature has a significant effect on the reduction reaction. At a given temperature, the highest rate was obtained at initial stages whereas the minimum rate was observed at the later stages due to the formation of dense iron layer. The activation energy values (Ea) at the early stages was 39.23kJ mol -1 revealed that the reduction is most likely controlled by a combined effect of gaseous diffusion and interfacial chemical reaction mechanism. At later stages, the Ea values were 54.19 kJ mol-1 indicated that the interfacial chemical reaction is the rate controlling mechanism. Testing of the mathematical formulations derived from the gas-solid reaction model confirmed these controlling mechanisms. The non-isothermal reduction experiments were carried out using different heating rates which showed a considerable effect on the degree of reduction. The reduction conversion continuously increased with rise in temperature. The reduction mechanism was predicted from model free and model fitting. The activation energy values were ranging from 135-40 kJ.mol-1 indicating that gas diffusion is the rate controlling step.
The present study contributes to the current worldwide activities aiming to replace fossil carbon in steel making processes with hydrogen causing considerable reduction of greenhouse gas emissions. Compacts prepared from iron oxide pellets fines were isothermally reduced in pure hydrogen gas and a mixture of hydrogen and argon in the temperatures range from 700 to 1100 °C. The total weight loss produced during the reduction process was continuously recorded using thermogravimetric analysis (TG) technique. The findings demonstrated that the temperature has a considerable impact on the conversion and reduction rates. At a given temperature, the reduction rate was accelerated as the amount of H2 increased in the reducing gas. The results indicated that H2 content does not have an effect on reduction behavior, when it is higher than 80%. The reduction reaction of samples was shown to takes place in a step wise manner from hematite to metallic iron. The reduction kinetic and mechanism were deduced from the application of mathematical models and the morphological structure of the reduced samples and correlated with the apparent activation energy (Ea) values. The Ea values at the early, intermediate and final stages were 16.36, 29.24 and 49.35 kJ/mole, respectively. The early stage of the reduction process was controlled by chemical reaction, whereas the gaseous diffusion was controlled the latter stage. At the intermediate stage, the reduction process was controlled by mixed mechanism of gaseous diffusion and chemical reaction. Graphical Abstract
This study examines the isothermal and non-isothermal reduction behaviors of iron ore compacts in a pure hydrogen atmosphere and compares the results obtained during the reduction process by CO. The different phases accompanying the reduction reactions were identified using X-ray diffraction (XRD) and its morphology was microscopically examined. In isothermal experiments, temperature plays a significant role in the reduction process. At any given temperature, the reduction rate during the initial stages is higher than that during the final stages. The reduction rate in H2 atmosphere was faster than in CO gas. The comparison of activation energy values suggested that reduction with H2 is more efficient than with CO. At the same temperature, the time required to achieve a certain degree of reduction was lower when using H2 gas than CO atmosphere. In non-isothermal tests, the heating rate has a significant effect on the reduction rate and reduction extent. At the same heating rate, the degree of reduction was higher in H2 atmosphere than in CO gas. Based on experimental data, the parameters of reaction kinetics were deduced by application of model-free and model-fitting methods. The reduction in H2 atmosphere was controlled by nucleation model (Avrami-Erofeev model), while the CO reduction reaction was controlled by gas diffusion.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.