The aim of this study was to compare implant-bone interface stresses and peri-implant principal strains in anisotropic versus isotropic three-dimensional finite element models of an osseointegrated implant in the posterior mandible. We obtained anisotropic (transversely isotropic) elastic constants for mandibular bone and derived equivalent isotropic constants by averaging over all possible spatial orientations. A finite element model was constructed using ten-node tetrahedral p-elements, providing curved edges where necessary and increasing the accuracy of the results in regions of high stress gradients. Perfect bonding was assumed at the implant-bone interface. An oblique load was applied at the coronal aspect of the crown with 100 N vertical and 20 N bucco-to-lingual components. Implant-bone interface stresses exceeded reported bond strengths and principal strains reached yield strain levels in the cortical crest. Anisotropy increased what were already high levels of stress and strain in the isotropic case by 20 to 30% in the cortical crest. In cancellous bone, anisotropy increased what were relatively low levels of interface stress in the isotropic case by three- to four-fold to exceed bond strength levels. Anisotropy has subtle, yet significant effects on interface stresses and peri-implant strains and careful consideration should be given to its use in finite element studies of dental implants.

The elastic moduli have not been reported for cancellous bone from the edentulous mandible. Accurate values are needed for finite element modeling of the mandible. The aim of this study was to determine elastic modulus values in three orthogonal directions for cancellous bone taken from an edentulous jaw and to relate these values to apparent density and volume fraction. Seven samples were obtained from the edentulous mandible of a 74-year-old female. Young's modulus was determined by compression testing of cubes cut with the faces aligned with the anatomic axes. Bone volume fraction averaged 0.33 (SD 0.14) and apparent density averaged 0.55 g/cc (SD 0.29). Young's modulus was greatest in the mesio-distal direction (mean 907 MPa, SD 849 MPa), followed by the bucco-lingual (mean 511 MPa, SD 565 MPa) and infero-superior direction (mean 114 MPa, SD 78 MPa). The infero-superior direction was less than the bucco-lingual (P = 0.03) and mesio-distal (P = 0.002). The mesio-distal and bucco-lingual directions could not be shown to be different (P = 0.32). This suggests a model of transverse isotropy for cancellous bone in the jaw, where the symmetry axis is along the infero-superior (weakest) direction.

No abstract

To test the hypothesis that a flat plane interocclusal appliance affects the electromyographic (EMG) activity of the temporalis and masseter muscles in pain-free individuals, maxillary splints were fabricated for 20 individuals who reported no history, signs or symptoms of myofascial pain or arthralgia as determined by two trained, independent examiners. Subjects were instructed to establish light tooth contact, maximum clenching, and moderate clenching with/without the splint in place (as determined by random assignment) while EMG data from the left and right temporalis and masseter muscles were recorded. A 5-min biofeedback training session to relax the masticatory muscles was followed by a repetition of the tooth contact/clenching tasks with/without the splint in place. With the splint in place, the activity of the temporalis muscles decreased for all tasks, significantly for the left and right temporalis under maximal clenching and for the right temporalis under moderate clenching. In contrast, the activity of the masseter muscles increased under light and moderate clenching (significantly for the left masseter under moderate clenching) and decreased slightly under maximal clenching. The effectiveness of interocclusal appliances may be due to mechanisms other than redistribution of adverse loading.

Supplemental Digital Content is available in the text.