Optical-to-electrical conversion, which is the basis of the operation of optical detectors, can be linear or nonlinear. When high sensitivities are needed, single-photon detectors are used, which operate in a strongly nonlinear mode, their response being independent of the number of detected photons. However, photon-number-resolving detectors are needed, particularly in quantum optics, where n-photon states are routinely produced. In quantum communication and quantum information processing, the photon-numberresolving functionality is key to many protocols, such as the implementation of quantum repeaters 1 and linear-optics quantum computing 2 . A linear detector with single-photon sensitivity can also be used for measuring a temporal waveform at extremely low light levels, such as in longdistance optical communications, fluorescence spectroscopy and optical time-domain reflectometry. We demonstrate here a photon-number-resolving detector based on parallel superconducting nanowires and capable of counting up to four photons at telecommunication wavelengths, with an ultralow dark count rate and high counting frequency.Among the approaches proposed so far for photon-numberresolving (PNR) detection (Table 1) are detectors based on charge integration or field-effect transistors 3-5 , which are, however, affected by long integration times, leading to bandwidths of ,1 MHz. Transition edge sensors 6 operate at 100 mK and show long response times (several microseconds). Approaches based on photomultipliers 7 and avalanche photodiodes, such as the visiblelight photon counter 8,9 , two-dimensional arrays of avalanche photodiodes 10,11 and time-multiplexed detectors 12,13 are not sensitive or are plagued by high dark count rates (DKs) and long dead times in the telecommunication spectral windows. Arrays of single-photon detectors (SPDs) also involve complex readout schemes 11 or separate contacts, amplification and discrimination 14. The parallel nanowire detector (PND) presented here significantly outperforms these approaches in terms of simplicity, sensitivity, speed and multiplication noise.The basic structure of the PND comprises the parallel connection of N superconducting nanowires, each connected in series to a resistor R 0 (Fig.

No abstract

No abstract

We have measured the ultrafast reset time of NbN superconducting single photon detectors (SSPDs) based on a design consisting of N parallel superconducting stripes. Compared to a standard SSPD of identical active area, the parallel SSPD displays a similar detection efficiency and a kinetic inductance, which is divided by N2. For N=12, the duration of the voltage detection pulse is reduced by nearly two orders of magnitude down to 200ps. The timing jitter associated with the rising front is only 16ps. These results open a way to efficient detectors with ultrahigh counting rate exceeding 1 GHz.

No abstract

We fabricated and characterised nanowire superconducting single-photon detectors (SSPDs) made of 4 nm thick amorphous Mo x Si 1−x films. At 1.7 K the best devices exhibit a detection efficiency up to 18% at 1.2 µm wavelength of unpolarised light, a characteristic response time of about 6 ns and timing jitter of 120 ps. The detection efficiency was studied in wavelength range from 650 nm to 2500 nm. At wavelengths below 1200 nm these detectors reach their maximum detection efficiency limited by photon absorption in the thin MoSi film.

Time resolution is one of the main characteristics of the single photon detectors besides quantum efficiency and dark count rate. We demonstrate here an ultrafast time-correlated single photon counting (TCSPC) setup consisting of a newly developed single photon counting board SPC-150NX and a superconducting NbN single photon detector with a sensitive area of 7 × 7 μm. The combination delivers a record instrument response function with a full width at half maximum of 17.8 ps and system quantum efficiency ∼15% at wavelength of 1560 nm. A calculation of the root mean square value of the timing jitter for channels with counts more than 1% of the peak value yielded about 7.6 ps. The setup has also good timing stability of the detector-TCSPC board.

It was investigated the possibility of creating NbN superconducting single-photon detectors with saturated dependence of quantum efficiency versus normalized bias current. It was shown that the saturation increases for the detectors based on finer films with a lower value of R s300 /R s20 . The decreasing of R s300 /R s20 related to increasing influence of quantum corrections to conductivity of superconductors and, in its turn, to decreasing electron diffusion coefficient. The best samples has constant value of system quantum efficiency 94% at I b /I c~0 .8 and wavelength 1310 nm.